EEW 6.1 Circuit Board

Description

This is a replacement EEW 6.1 circuit board.

This video shows how to install it on the EEW 6.0.

Here are some additional notes about installing this on the EEW 6.0.

• If you have an EEW 6.0 from the first batch the connector for the speed controller is slightly different.  To accommodate this you will need to remove the plastic white shroud on the circuit board for this plug.  You can remove this either by pulling it off with a plyers or heating it some and then pulling it off with a plyers.  The first batch of the EEW 6.0 will not have the black tape to the top of the circuit board that I mentioned in the video.
• The wire from the SZ switch is just long enough.  This is ok, and I just want to note it.